1. Make sure the adapter is not plugged into the wall.
2. Then chop off the little plug at the end of wire.
3. Have a half inch cut between the two conductors, then pull them apart.
4. Strip the 2 conductors, then twist the cooper strands
5. Insert one heat-shrink tubing into one of the conductors.
6. Solder the wires to the shorter end of the 2-pin conductor that came with the toolkit
7. Cut off the negative side of conductor shorter
8. Insert another heat-shrink tubing into the two conductors.
 |
| The newly constructed 5V power supply is working properly |
No comments:
Post a Comment